Perpustakaan judul masih dalam tahap pengembangan, admin siap menampung kritik dan saran
Pembuatan Dan Pengujian Reaktor Pirolisis Umpan Styrofoam Menggunakan Pemanas Elektrik
Fitria Febriyanti (2020) | Tugas Akhir | -
Bagikan
Ringkasan
Tugas Akhir ini membahas tentang pembuatan reaktor pirolisis umpan styrofoam menggunakan pemanas elektrik, analisa proses pirolisis dan neraca massa dan energi pada alat tersebut. Pembuatan rektor pirolisis dilakukan secara mandiri melalui pembuatan desain tabung reaktor 2 liter, pembelian bahan, peminjaman alat, pembentukan bahan, instalasi kontrol dan kelistrikan, dan pemasangan isolator. Alat pemanas elektrik terbuat dari kawat nikelin yang dihubungkan langsung dengan aliran arus dan dikontrol oleh relay, sehingga temperatur reaktor dapat diatur. Proses pengujian dimulai dari pelelehan styrofoam yang terjadi pada temperatur 300⁰C-450⁰C dan proses dekomposisi terjadi pada temperatur 500⁰C. Hasil dari penelitian ini menunjukan bahwa daya yang digunakan untuk menjalankan alat adalah 1386 Watt, Rugi-rugi perpindahan panas pada isolator 48,482 Watt dan rugi-rugi terbuang ke lingkungan 118,83 Watt. Kinerja alat reaktor pirolisis umpan styrofoam menggunakan pemanas elektrik ini adalah 0,108 ml/kj. Massa 500 gram styrofoam menghasilkan asap cair 90 ml (14,8% dari total massa) dan produk sisa yang mengendap pada alat sebanyak 521 ml. Kata Kunci: Proses pirolisis, reaktor pirolisis, pemanas elektrik, styrofoam.
Ringkasan Alternatif
This Final Project about the manufacture of styrofoam feed pyrolysis reactors using electric heaters, pyrolysis process analysis and mass and energy balance in the device. The device are made independently through the design of a 2-liter reactor tube, material purchase, equipment lending, material formation, electrical, control, and isolator installation. Electric heating devices made of nickel wire are connected directly to the flow of current and controlled by a relay, so that the reactor temperature can be regulated. The testing process starts from melting Styrofoam which occurs at a temperature of 300⁰C-450⁰C and the decomposition process occurs at a temperature of 500⁰C. The results of this study indicate that the power used to run the tool is 1386 Watt, heat transfer losses in the 48.482 Watt insulator and losses lost to the environment 118.83 Watt. The performance of a styrofoam feed pyrolysis reactor using an electric heater is 0.108 ml/kj. The 500gram styrofoam mass produces 90 ml of liquid smoke (14.8% of the total mass) and the residual products that settle to the device are 521ml. Keywords: pyrolysis process, pyrolysis reactor, electric heating, styrofoam.