Perpustakaan judul masih dalam tahap pengembangan, admin siap menampung kritik dan saran
Pembuatan Preheater Menggunakan Heat Exchanger Coil on Tube Sebagai Penghemat Konsumsi Energi Listrik Water Dispenser
Armelinda Morina Wijaya (2017) | Tugas Akhir | -
Bagikan
Ringkasan
Kehadiran dispenser merupakan implementasi guna memudahkan konsumsi air minum bagi manusia. Untuk proses pendinginan air, sistem refrigeran yang digunakan pada dispenser merupakan sistem refrigerasi uap sederhana dimana terjadi pelepasan kalor dari kondensor menuju ke lingkungan. Penggunaan preheater bertujuan untuk menaikan temperatur air dengan memanfaatkan panas dari saluran discharge kompresor, sehingga diharapkan dapat menghemat penggunaan konsumsi daya listrik karena akan mempersingkat waktu pemanasan dan pendinginan pada sistem. Preheater yang dibuat terdiri dari reservoir berbahan plastik polypropylene dengan kapasitas 1.5 liter dan Heat Exchanger tipe Coil on Tube berbahan pipa tembaga dengan jumlah lilitan sebanyak 13 dan diameter 7 cm. Pengujian dilakukan ketika sistem menggunakan preheater dan ketika sistem tidak menggunakan preheater. Berdasarkan pengujian dan perhitungan yang telah dilakukan maka diperoleh hasil bahwa temperatur air maksimal yang dapat dicapai preheater adalah 36.8⁰C dengan penghematan maksimal yang terjadi pada sistem secara keseluruhan mencapai 40 % Kata Kunci: Dispenser, Penghematan, Sistem Refrigerasi, Heat Exchanger, Preheater.
Ringkasan Alternatif
The presence of dispensers is an implementation to facilitate the consumption of drinking water for humans. For the water cooling process, the refrigerant system used in the dispenser is a simple vapor refrigeration system where there is a heat release from the condenser to the environment. The use of preheater aims to increase the water temperature by utilizing heat from the compressor discharge channel, so it is expected to save the use of power consumption because it will shorten the heating and cooling time in the system. The preheater is made up of a polypropylene plastic reservoir with a capacity of 1.5 liters and Coil Heat Exchangers on Tube made from copper pipe with the number of windings is 13 and 7 cm diameter. Testing is done when the system uses preheater and when the system does not use preheater. Based on the tests and calculations that have been done then obtained the result that the maximum water temperature that can be achieved preheater is 36.8⁰C with maximum savings that occur on the system as a whole reaches 40%. Keywords: Dispenser, Saving, Refrigeration System, Heat Exchanger, Preheater.