Perpustakaan judul masih dalam tahap pengembangan, admin siap menampung kritik dan saran
Perbandingan Kekuatan Material Komposit Hasil Metode Hand Lay-Up, Vacuum Bag, dan Vacuum Infusion pada UAV Flying Wing
Devaranaldo Putra Gusti Pratama (2021) | Tugas Akhir | -
Bagikan
Ringkasan
Pada Tugas Akhir (TA) ini berisi tentang bagaimana perbedaan kekuatan material komposit yang dibuat menggunakan metode hand lay-up, vacuum bag, dan vacuum infusion yang dimana perbedaan kekuatan materialnya akan diamati pada juga Unmanned Aerial Vehicle (UAV) flying wing. Komposit adalah material yang terdiri dari dua material atau lebih yang dimana masing-masing material memiliki sifat yang berbeda tetapi saat digabungkan mengasilkan sifat yang baru tanpa menghilangkan sifat awal material tersebut. Metode yang digunakan dalam pengerjaan TA ini adalah kajian teoritis, pengujian material, dan simulasi. Kajian teoritis berutujuan untuk mengumpulkan landasan teori yang dapat membantu pengerjaan TA. Pengujian material berupa uji Tarik untuk mengetahui pebedaan kekuatan material laminat komposit hand lay-up, vacuum bag, dan vacuum infusion. Perhitungan analitik untuk mengetahui fraksi volume masing masing komposit, specific strength dan specific modulus. Simulasi untuk mengetahui perbedaan UAV yang menggunakan material komposit hand lay-up, vacuum bag, dan vacuum infusion. Hasil dari proses pengujian material didapatkan material komposit vacuum infusion gaya maksimum yang diterimanya sebesar 42,113 Mpa kemudian vacuum bag sebesar 38,14 MPa dan hand lay-up sebesar 24,81 MPa. Pada perhitungan perhitungan specific strength dan specific modulus yang dilakukan didapatkan komposit vacuum infusion memiliki nilai terbesar yaitu 23,27 kNm/kg dan 627,83 kNm/kg. Untuk hasil simulasi didapatkan UAV yang menggunakan material komposit vacuum bag memiliki safety factor terbesar yaitu 29,05.
Ringkasan Alternatif
This Final Project (TA) contains about how the differences in the strength of composite materials made using the hand lay-up, vacuum bag, and vacuum infusion methods where the difference in material strength will be observed in the Unmanned Aerial Vehicle (UAV) flying wing. Composites are materials that consist of two or more materials, each of which has different properties, but when combined, it produces new properties without losing the original properties of the material. The methods used in the work of this TA are theoretical studies, material testing, and simulations. The purpose of the theoretical study is to gather a theoretical basis that can help work on TA. Material testing in the form of Tensile test to determine the difference in the strength of the composite laminate material by hand lay-up, vacuum bag, and vacuum infusion. Analytical calculations to determine the volume fraction of each composite, specific strength and specific modulus. Simulation to determine the differences in UAVs using hand lay-up composite materials, vacuum bag, and vacuum infusion. The results of the material testing process showed that the maximum force of the composite material for vacuum infusion was 42,113 MPa, then the vacuum bag was 38.14 MPa and the hand lay-up was 24.81 MPa. In the calculation of the specific strength and specific modulus calculations performed, the vacuum infusion composite has the largest values, namely 23.27 kNm / kg and 627.83 kNm / kg. For the simulation results, it is obtained that the UAV which uses a vacuum bag composite material has the largest safety factor, namely 29.05.