Perpustakaan judul masih dalam tahap pengembangan, admin siap menampung kritik dan saran
RANCANG BANGUN ALAT UJI RUNNING-IN UNTUK SISTEM KONTAK PASANGAN DISC DAN PASANGAN GEAR
Petrus Londa (2014) | Tesis | -
Bagikan
Ringkasan
Keausan merupakan fenomena tribologi yang terjadi pada setiap peralatan akibat kontak mekanik antara dua komponen. Dalam kurun waktu yang lama keausan ini akan menimbulkan kerusakan pada peralatan. Untuk meningkatkan keandalan dan efisiensi peralatan, maka fenomena keausan ini perlu dikaji lebih lanjut. Didalam ilmu tribology para peneliti membagi proses terjadinya keausan akibat kontak mekanik tersebut menjadi tiga fase, yaitu fase running-in, fase steady state (fase tunak) dan fase wear-out. Untuk mengetahui secara cepat kondisi dari ketiga fase tersebut diperlukan alat uji running-in. Tesis ini difokuskan pada rancang bangun alat uji running-in. Alat ini dipakai untuk menguji komponen yang terdiri dari dua roda gigi dan dua buah piringan (two disc) yang terbuat dari material yang dapat divariasikan jenisnya. Perancangan mekanismenya memungkinkan sisi kedua piringan pada arah radial saling kontak ketika kedua piringan tersebut berputar (rolling contact) dan dapat divariasikan beban maupun putaran. Untuk itu metode perancangan Pugh dapat memberikan solusi, karena dengan metode ini semua konsep produk akan dinilai dan konsep produk terbaik yang akan dikembangkan menjadi produk. Pengujian dilakukan secara eksperimen untuk mengetahui fenomena keausan yang terjadi mulai dari kondisi running-in sampai kondisi steady state. Hasil rancangan menunjukan bahwa alat uji dapat digunakan untuk menentukan variabel-variabel dalam proses running-in. Dengan variasi jumlah putaran (maksimal 2800 rpm), beban tekan (maksimal 5 kg) dan beban torsi yang dapat dikontrol (5 kg) serta arah putaran specimen yang dapat diatur, maka gaya gesek pada permukaan specimen dapat diketahui, sedangkan variabel yang diukur adalah perubahan kekasaran permukaan.
Ringkasan Alternatif
Wear is a phenomenon of tribology that occured in every equipment due to contact between two component. In a long period the wear will cause damage to the equipment. To increase the reliability and efficiency of equipment, this phenomenon needs to be studied further. In the science of tribology, researchers divided the process of the wear due to the mechanical contact into three phases, namely running-in phase, steady state phase and wear-out phase. For quickly determine the conditions of these three phases the running-in tester is required. This thesis focuses on the design and manufacture of running-in test equipment. This tool is used to test components consisting of two gears and two discs are made of material that can be varied kind. The design of the mechanism allows the both disc contact one another on radial direction when both disc rotating then loads and rotation can be varied. For that Pugh design method can provide a solution, because with this method all product concepts will be assessed and the best concept of products will be developed into the products. Tests carried out experimentally to determine the wear phenomenon that occurs from running-in conditions until steady state conditions. Results showed that test equipment can be used to determine the variables in the running-in process. By varying the amount of rotation (maximum 2800 rpm), compressive load (maximum 5 kg) and torque load that can be controlled (5 kg) and the direction of rotation of the specimen can be set, then the friction force on the surface of the specimen can be found, while measured variable is the change of surface roughness.