Perpustakaan judul masih dalam tahap pengembangan, admin siap menampung kritik dan saran
Rancang Bangun Modul Relay GFR Dengan Pembumian Langsung Pada Sistem Jaringan Tegangan Menengah Menggunakan Residual Sekunder Trafo Arus
Sani Rizki Pratama Ginting (2019) | Tugas Akhir | Teknik Elektro
Bagikan
Ringkasan
Pada sistem pembumian langsung sensor gangguan tanah yang dapat dilakukan dengan pemasangan trafo arus secara langsung pada titik gronding sekunder transformator daya atau generator, atau dengan sensor residual dari sekunder trafo arus. Pada tugas akhir ini dibuat sensor residual arus sekunder trafo arus dari tiga buat trafo arus dirangkai menjadi rangkaian deteksi gangguan tanah. Penyesuain besaran arus diperlukan sesuai besar arus gangguan yang terjadi dalam simulator pada gangguan satu fasa ke tanah. Hal ini mempertimbangkan range aluminasi dari trafo arus dan besar arus gangguan yang terjadi. Hasil yang akan diperoleh dari tugas akhir ini adalah sensor dapat menampilkan besaran arus gangguan tanah yang sebanding sesuai rasio trafo arus yang terpasang. Sensor juga dapat menampilkan kinerja yang besar sesuai pada relai gangguan tanah, dengan cara disimulasikan bersama dengan relai gangguan tanah. Sehingga tugas akhir ini akan bisa mensimulasikan percobaan proteksi gangguan tanah mengunakan sensor arus residual sekunder trafo arus Kata kunci: gangguan tanah,arus residual sekunder transformator arus.
Ringkasan Alternatif
In a direct grounding system the ground disturbance sensor can be performed by the installation of the current transformer directly at the secondary gronding point of the power transformer or generator, or by the residual sensor of the secondary current transformer. In this final project is made residual current sensor of secondary current transformer from three for current transformer arranged into detection circuit of ground fault. Flow rate adjustment is required according to the amount of noise current that occurs in the simulator on a single phase noise to ground. This takes into consideration the range of aluminum from the current transformer and the magnitude of the fault current that occurs. The result to be obtained from this final task is the sensor can show the amount of current of the ground fault that is equal to the ratio of current transformer that is attached. The sensor can also display a large performance according to the ground fault relay, in a way simulated along with the ground fault relay. So this final project will be able to simulate ground fault protection experiments using residual current sensor secondary current transformer Keywords: ground fault, residual current secondary transformer current.